The whole process

Plastic PVC Gaskets, Seals and Extrusions

Shown from the bottom of this image, up, the pellets are heated, mixed and pushed through the dies, then cooled and dried before being tested and prepared for storage and transport.

It’s a short but interesting manufacturing process. The material comes in pellet form that is control fed through a hopper into a spiralling screw or ram. The pellets are heated, mixed and compressed as they are fed through the screw, and finally forced through the die into its final shape. After the gasket is extruded, it is immediately cooled in chilled water, and then dried before being cut into designated lengths and boxed, or rolled onto a spool.

Leave a Reply

Your email address will not be published.